E1 High

E1 - aux Air Conditioner

中文

含义

E1 为室内环境温度传感器故障。室内机进风口处的热敏电阻检测房间实际温度,传感器开路或短路导致空调无法正常控温。

常见原因

  1. 传感器热敏电阻老化,阻值漂移超出正常范围
  2. 传感器连接线断裂或端子氧化接触不良
  3. 传感器受潮导致短路
  4. 控制板传感器检测电路故障
  5. 传感器物理损坏(如被撞击或昆虫侵入)

自助排查

  1. 检查室内机进风口处温度传感器外观是否完好
  2. 断电后打开面板,检查传感器插头是否松动或脱落
  3. 用万用表测量传感器阻值,常温下正常约为 5-10kΩ
  4. 如传感器外观正常但测量异常,更换同型号传感器
  5. 若更换后仍报故障,控制板检测电路可能损坏,联系奥克斯售后

English

Meaning

Room temperature sensor (indoor ambient thermistor) open or short circuit. Located at the indoor unit air intake, used to detect the actual room temperature.

Common Causes

  1. Thermistor aging causing resistance drift
  2. Sensor connection wire broken or terminal oxidized
  3. Moisture ingress causing short circuit
  4. Control board detection circuit fault
  5. Sensor physically damaged

Self-Check Steps

  1. Visually inspect the room temperature sensor at the indoor unit air intake
  2. Power off, open the panel, check sensor connector for looseness
  3. Measure sensor resistance with a multimeter; expected 5-10kΩ at room temperature
  4. If abnormal reading, replace with the same type sensor
  5. If fault persists, contact AUX after-sales service

More aux Air Conditioner Error Codes