中文
含义
上盖锁（Lid Lock）故障——洗涤过程中上盖锁未正常锁定或位置开关信号异常。此代码仅出现在波轮/顶开式机型。
常见原因
- 上盖锁组件中的PTC加热元件失效，锁闩无法动作到位。
- 上盖位置开关（磁簧开关或微动开关）损坏或位置偏移。
- 上盖上的锁舌（Striker Tab）断裂或变形，无法正确接触锁体。
- 上盖锁线束连接松动、端子氧化或线路断路。
- 主控板上控制上盖锁的可控硅（Triac）击穿或驱动电路异常。
自助排查
- 打开上盖，目视检查上盖锁舌（塑料钩）是否完整无断裂。
- 关闭上盖，听是否有锁闩吸合的”咔嗒”声；无声音则PTC或供电可能异常。
- 断开上盖锁连接器，测量端子间阻值（PTC通常几十欧姆）；开路则锁体需要更换。
- 检查线束插头是否插紧、端子有无锈蚀或退针。
- 若锁体正常而仍报F34，需检查主控板可控硅输出或更换主控板。
English
Meaning
Lid lock fault — the lid lock assembly failed to latch or the lid position switch signal is abnormal during operation. This error applies only to top-load (vertical-axis) models.
Common Causes
- PTC heating element inside the lock assembly has failed, preventing the latch from engaging.
- Lid position switch (reed switch or micro switch) is broken or misaligned.
- Striker tab on the lid is cracked or broken, failing to contact the lock body.
- Lid lock harness connector is loose, terminals are corroded, or wiring is open.
- Control board triac that drives the lid lock is shorted or the drive circuit is faulty.
Self-Check Steps
- Open the lid and visually inspect the plastic striker tab for cracks or breakage.
- Close the lid and listen for a “click” as the latch engages. No click suggests a failed PTC or missing power.
- Unplug the lid lock connector and measure resistance across the PTC terminals (typically tens of ohms). An open reading means the lock assembly must be replaced.
- Verify the harness connector is fully seated and terminals are free of corrosion or pushed-out pins.
- If the lock assembly tests good but F34 persists, check the control board triac output or replace the control board.