OP - 富及第 冰箱

中文

含义

OP 代码表示冰箱门已打开时间过久，触发了开门报警。冰箱门磁开关检测到门未关闭或未关严，主控板在预设延时后（通常1-2分钟）显示该代码并发出蜂鸣提醒。此报警的主要目的是防止冷气外泄导致能耗上升和食物变质，同时也提醒用户避免门封条长时间受压变形。

常见原因

1. 冰箱门未完全关闭，门封条与箱体之间有缝隙。
2. 门封条老化变形、破损或吸附力不足，关门后仍有微小缝隙。
3. 门磁开关（干簧管）本身故障，状态卡在”开门”位。
4. 门铰链变形或下沉，导致门无法正常对齐闭合。
5. 冰箱内物品摆放突出，顶住了门无法关严。

自助排查

1. 检查冰箱门是否完全关闭，聆听是否有”咔嗒”吸合声，确认门磁开关动作。
2. 清理门封条上的食物残渣和污垢，用湿布擦拭后检查封条是否平整贴合。
3. 将手电筒放入冰箱内并关上门，从外部观察是否有漏光处——漏光即表示缝隙。
4. 调整冰箱内部搁架上的物品，确保没有瓶罐或容器突出阻挡门关闭。
5. 若门封条老化或门铰链变形，可试用吹风机加热封条使其恢复弹性，或调整铰链螺丝。

---

English

Meaning

The OP code indicates the refrigerator door has been open for an extended period, triggering the door alarm. The door switch detects the door is ajar, and after a preset delay (usually 1-2 minutes), the control board displays this code and sounds a buzzer. This alarm helps prevent cold air loss, higher energy consumption, and food spoilage, while also protecting the door gasket from prolonged compression.

Common Causes

1. The refrigerator door is not fully closed with a visible gap between the gasket and the cabinet.
2. Door gasket aged, deformed, torn, or has lost magnetic pull — small gaps remain even when closed.
3. Door switch (reed switch) failed internally, stuck in the “door open” position.
4. Door hinge bent or sagging, preventing proper alignment and full closure.
5. Food items inside the refrigerator protruding and physically blocking the door from closing.

Self-Check Steps

1. Close the door firmly and listen for the magnetic click that confirms the door switch has engaged.
2. Clean the door gasket with a damp cloth to remove food debris and check that it sits flush against the cabinet.
3. Place a flashlight inside the refrigerator, close the door, and check for light leaks from outside — any light indicates a gap.
4. Rearrange items on shelves to ensure no containers or tall bottles are blocking the door from closing fully.
5. If the gasket is hardened or the hinge is sagging, gently heat the gasket with a hair dryer to restore flexibility, or adjust the hinge screws to realign the door.