E2

E2 - 飞利浦 空气净化器

中文

含义

风扇电机故障。净化器通电运行但风扇不转、转速异常或伴有异响,空气无法循环净化。

常见原因

  1. 风扇电机轴承磨损或干涩导致转子卡滞
  2. 电机驱动控制板(MOSFET或驱动IC)烧毁
  3. 电机霍尔传感器损坏导致无转速反馈信号
  4. 风扇叶片积尘严重导致动平衡失调和噪音
  5. 电机绕组局部短路导致转速偏低且发热严重

自助排查

  1. 断电后手动拨动风扇叶片检查是否转动顺畅
  2. 听电机是否有”嗡嗡”声但不转动——可能是启动电容损坏
  3. 清洁风扇叶片上的积尘(使用软毛刷或压缩空气)
  4. 检查电机连接器是否牢固插入驱动板插座
  5. 测量电机供电电压是否正常——若供电正常但电机不转需更换电机

English

Meaning

Fan motor failure. The purifier powers on but the fan does not spin, runs at abnormal speed, or makes unusual noises, stopping air circulation.

Common Causes

  1. Worn or dry fan motor bearings causing rotor binding
  2. Burnt motor driver components (MOSFET or driver IC) on the control board
  3. Failed Hall effect sensor in the motor providing no speed feedback
  4. Heavy dust buildup on fan blades causing imbalance and vibration noise
  5. Partial short circuit in the motor windings causing low speed and overheating

Self-Check Steps

  1. Power off and manually spin the fan blade to check for smooth rotation
  2. Listen for a humming sound from the motor without rotation — indicates a possible start capacitor fault
  3. Clean the fan blades with a soft brush or compressed air
  4. Verify the motor connector is fully seated on the driver board
  5. Measure motor supply voltage — if voltage is normal but the motor does not run, replace the motor assembly

更多 飞利浦 空气净化器 错误代码