E013 - 康佳 电视

中文

含义

康佳电视检测到 LVDS（低压差分信号）排线连接异常。E013 错误代码表示主控板与逻辑板之间的 LVDS 线缆通信链路不稳定或中断。屏幕可能出现画面闪动、彩色噪点、无图像或图像错位，但背光通常正常。

常见原因

1. LVDS 排线插头松动或未插到位，导致部分差分信号对断开。
2. LVDS 排线内部的铜线因反复弯折而断裂——尤其是经常调整屏幕角度的电视。
3. LVDS 排线屏蔽层接地不良，引入外部电磁干扰导致信号眼图变差。
4. 排线插头锁扣损坏或卡扣断裂，无法将排线固定在插座中。
5. LVDS 排线过长产生的信号衰减，在 1080p/4K 高频信号下尤为明显。
6. 排线金手指被电解液或其他污染物腐蚀。

自助排查

1. 断电后将 LVDS 排线两端的插头重新插拔，确保锁扣扣紧到位。注意排线方向，避免反插。
2. 轻轻扭动排线观察画面变化——画面随排线扭动而改善或恶化说明内部导线断裂。
3. 检查排线表面是否有明显的折痕、烧焦或腐蚀痕迹。
4. 用酒精擦拭排线金手指，清除氧化物或污染物后重新连接测试。
5. 如排线损坏，可记录排线型号（通常在排线两端印有零件号），联系康佳售后购买替换。

English

Meaning

The Konka TV has detected an abnormal LVDS (Low-Voltage Differential Signaling) cable connection. Error code E013 indicates that the communication link between the main board and the logic board via the LVDS cable is unstable or broken. The screen may show flickering, colored noise, no image, or misaligned image, but backlight is usually normal.

Common Causes

1. The LVDS cable connector is loose or not fully seated, causing one or more differential signal pairs to disconnect.
2. Broken copper wires inside the LVDS cable from repeated bending — especially on TVs whose screen angle is frequently adjusted.
3. Poor ground connection on the LVDS cable shielding, allowing external EMI to degrade the signal eye pattern.
4. Damaged or broken latch on the cable connector that cannot hold the cable in place.
5. Signal attenuation from an excessively long LVDS cable, more pronounced at 1080p/4K high-frequency signals.
6. Corrosion of the cable gold fingers by electrolyte leakage or other contaminants.

Self-Check Steps

1. Power off, then reseat the LVDS cable connectors at both ends and ensure the locking tabs click firmly into place. Note the cable orientation to avoid reverse insertion.
2. Gently wiggle the LVDS cable while watching the screen — visual improvement or degradation with cable movement suggests broken internal wires.
3. Inspect the cable surface for visible creases, burn marks, or signs of corrosion.
4. Clean the cable gold fingers with alcohol to remove oxidation or contaminants, then reconnect and test.
5. If the cable is damaged, note the part number (usually printed on the cable ends) and contact Konka after-sales service for a replacement.